An interesting opinion or view, but little back-up at this final link
Anyone with a $200 oscilloscope can measure 'visible wave forms' or fluctuating electrical 'quantity'. Any good EOD or LE can figure out what's going on with limited equipment. CI elements should be 'searching' for this 'signal'.
The first and easiest method:
Once the signal strength and 'wave form' are obtained, it's just a question of more power along the same freqs. Most EOD jamming devices run well over 100 grand, and need a lot of power and cooling. This system will unlikely work with camels So, we're looking for vehicles within 500 meters, an antenna or two on the roof, etc. The trouble with this (for both us and them) is, using such high tech jamming equipment requires a huge power source soaking up a lot of juice in order to perform. Worse (for them), they need to be real close, even with 10,000 watts of power.
What does all this Bravo Sierra mean ?
The signal cannot make contact, and when it can’t make contact, it doesn’t detonate...much like a cellular phone call that does not connect. No connection, but the enemy thinks the call went through.
The second method, although a more expensive approach is our current Warlock system, available almost anywhere except K-mart.
It doesn't do anything dramatic, it basically works by intercepting the signal sent from a remote location to the IED instructing it to detonate. Again, override the source and ....boom.
Find it and delete it.
Bookmarks